Chapter 608: A plan within a plan, a plan within a plan
"What can I do?"
Baiot asked eagerly: "Are you sure?"
"I'm not completely sure, I can only say half and half, let's bet! If we can't kill him, we are unlucky, if we can't kill him, we are lucky!"
Baiot grinned, he was optimistic.
"Okay, I used to go to Las Vegas when I had nothing to do. I like to gamble on luck."
Li Zheng explained his method once, and Bai Aot nodded frequently after listening. After nodding, the two began to act separately. After getting everything done, they retreated to a sniper point on the mountain. They found a cover to hide and set up their guns.
Get ready and wait for the "hunters" to come.
Baiot scolded his boss again while waiting out of boredom.
After scolding him for a while, he looked at his watch.
"Huh? Why haven't you shown up yet?" He looked at Li Zheng with confusion on his brows.
Li Zheng frowned. He had analyzed it before and said that the ADF's pursuers would arrive here within ten minutes.
The reason why it was so fast was because Li Zheng discovered a detail when he passed by here just now——
This detail is, how did the ADF armed personnel catch up with him and Bai Aote so quickly?
Every time I sit down and take a rest, the other person will stick to me like a dog-skin plaster.
How did they do that?
Then I thought about it, it’s absolutely impossible to rely on two legs. You have to search and chase, and it’s definitely not that fast.
Among all the pursuers, only the hunter could survive the high-intensity pursuit. Most of them were just militiamen and did not have that strong physical strength at all, so most of them would always fall behind.
What is the remaining reason why there is a large crowd of people every time they appear?
Until just now, when Li Zheng arrived at that intersection, he suddenly understood.
It's mobility!
The other party has a pickup truck!
Most of them pursued the hunt along the mountain road in pickup trucks. Some of the stronger ones followed the hunter, biting themselves and Baiot, and used the radio to guide the direction of the large group.
The place where we stopped before was a three-way intersection.浗
Li Zheng saw this intersection on the map when he was analyzing the retreat route, and immediately remembered it when he arrived at the scene.
This is an important transportation thoroughfare. Whether you are going back to point C or chasing to Goma Forest, this is the only way to go.
Therefore, pursuers will appear here anyway, unless they don't want to follow you anymore.
In this case, let’s just make some understanding here!
Li Zheng set up a booby trap at the three-way intersection. To be precise, it was a mine array.
Strictly speaking, the setting of booby traps is closely related to the setting of traditional mine formations, except that the setting of booby traps is more sophisticated and deceitful.
Learning how to lay booby traps is not a simple matter. You must first understand all kinds of regular mines (including anti-personnel mines, road and general vehicle destruction mines and anti-armor mines, etc.), the principles and principles of mine laying on roads, open areas and urban reclamation areas.
Courses on position defense and minework, blocking the movement routes of small/large units and other combat engineers.浗
After completing these basic techniques and knowledge, you will be qualified to further learn booby trap setting and countermeasures techniques.
In fact, booby traps are not necessarily designed to kill immediately. There are also booby traps that are fine if you hit them, but suffer disaster after you use them.
For example, during World War II, the German army on the Eastern Front discovered that Soviet soldiers liked to use captured German equipment. Sometimes, when the defense line was retreating, stick grenades that were not taken away in time would fly over to attack them.
Therefore, the German army deliberately made many grenades with ultra-short detonation fuses. When pulling out the bottom cover, the lead rope connected to the cover will be pulled, and the lead rope is connected to a glass bead.
When the glass bead is pulled, the friction between the paint on the surface of the bead and the inner tube wall will produce sparks and ignite the fuze. The time from the fuze burning to the detonation of the explosive is about 3 to 5 seconds, and the detonation time of these modified grenades is less than one.
Seconds later, the fuze was canceled and the detonator was directly ignited, causing the grenades to explode as soon as they were pulled. This caused a lot of trouble to the Soviet troops who liked to pick up equipment.
The design of booby traps usually tamper with the most common and inconspicuous things. For example, when a person walks into a dark room, the first thing he does is to look for the light switch, so he removes the light bulb and moves it along the glass.
Cut the joint with the copper ring, fill the glass sphere with explosives, install the copper ring, and put it back into the lamp holder. Once the switch is turned on, the sparks caused by the electricity will ignite the explosives. In this way, a booby trap will be created.
This is done, it is very simple to learn and convenient to use.
However, most booby traps still focus on the application of trip wires, and there is still a science in this. The first is the setting of the position of the trip wires. There are two most suitable heights for the horizontal height of the low trip wires.
, 1 from the ground. Because most modern soldiers wear combat boots, the position where high contact occurs is the toe. The toes of general combat boots have some degree of strengthening or hardening, and most of the toes
There is a gap between the toes and the toes, and the small contact of the leather toe is less likely to be directly transmitted to the feet or detected, and 1 height is the height of the boot opening and the position of the leggings. The opening position of the boot will be
A layer of seams is added to enhance the overall strength, and there are shoelace holes and shoelaces in the front. Plus leggings, two layers of trouser legs and the weight and friction of long-term marching. The part of the body that is least expected and will not feel it is probably
Here, let alone a thin line, I'm afraid I won't even bother to scream if I kick a stone. At this time, people are tired and the horse is exhausted, which is the best place to strike a mine. However, the trip wire is usually either a fishing line or a thin steel wire.
All of them will reflect light, so after installing the booby traps and trip wires, remember to do a matte finish. The easiest way is to paint the trip wires black with a pen.
Another type of booby trap is much more complicated, that is, the anti-booby trap. The characteristic of this type of booby trap is that it may be fine if left alone, but it will explode as soon as you try to dismantle it. The simplest design is the tension release device. What we mentioned earlier
Most of the trip wires used are tension devices. Both use strong springs to separate the two poles. The difference is that the tension device fixes the spring in the form of a latch. Once pulled open, the spring will spring the two poles together, but
In this method, as long as the guide wire is cut, the latch can still be in a safe position, while the tension release device directly uses the guide wire to pull the spring. If the guide wire is cut directly, the spring will be released, causing an explosion.
If it is cut off, it is really annoying that the booby trap is still in a ready-to-explode state. This is the struggle between the installer and the bomb-disposer. As for who will win with the spear and the shield?
That's really not necessarily the case.
The mine formation Li Zheng prepared for the ADF armed militia this time was called a V-shaped mine formation. He used up one jumping mine and two broad-blade mines on himself and Bai Aote.
V-shaped mine formation or projectile mine method, veterans in the PLA special forces like to call it one-for-two, usually consisting of one jumping mine and two powerful directional mines (broad-blade mines).
The jumping mine is in front, and the two directional mines are in the back, forming a V shape. When the person in front steps on the jumping mine, gravity pushes the fuze sleeve in the mine downward. After moving a certain distance, the stopper steel ball is released, and the strike
The needle loses control and hits the flash cap under the action of the spring, igniting the projectile charge, throwing the mine to a certain height, and the main charge fuze moves, causing the mine to explode.
The scariest thing about the V-shaped mine array is not the jumping mine, but the two directional mines placed in the grass on the roadside behind the jumping mine. When the jumping mine is picked up, the trip wire is pulled and the safety is torn off.
A directional mine contains at least 700 steel balls, with a killing angle of 60 degrees.
Two directional mines on the roadside, one on the left and one on the right, exploded together...
Tsk tsk, that situation is really not too pleasant, there is no one left alive within 50 meters.
"If you install a mine here, that guy will be stupid enough to come here and step on it? How can you be sure which hunter is walking in front?"
Bai Aote had no objection to Li Zhengbrai's methods, but he suspected that Li Zheng was setting up mines at the intersection to kill hunters and disagreed.
Li Zheng tied the trip wire of the last broadsword mine and put it in a ready state. Then he stood up and said to Bai Aote: "I didn't expect this mine formation to kill that hunter at all."