With the fire of the seventy -five millimeters of the rear -loading, the senior generals of a large number of votes such as Lin Ziran also used the telescope to observe the felling point in front of the cannon.
After a few seconds, I saw a low cigarette on the hills in front of a tens of meters high.
That small mountain head is the main artillery position of the army of the guardian of the county. According to the observation of the artillery observer, which small mountains have deployed at least 20 artillery, and many of them are nine -pound field guns and ten.
Eight pounds of howitzers.
It can be said that it is one of the largest artillery positions in the troops in the face of the face. The other two artillery positions have only more than a dozen artillery, and they are mainly five pounds of field artillery.
The three artillery positions of the enemy are the most threat, because this is also the reason why the lane gun cannon first firms this place after testing.
Unfortunately, this artillery shell did not accurately fall in the middle of the enemy's artillery position, but had a deviation.
However, the shelling at such a long distance is no professional watching equipment, but only relying on the experience of the artillery team and the manual calculation of the firing of the firing Yuan, which can hit the first fire shells in front of the tens of meters in front of the enemy position.
Inside, this is quite good.
Therefore, Lin Ziran did not have the dissatisfaction with the shells of this shell at all, but all smiled.
Because this is a long -distance shell with more than 3,500 meters. Although there is no hit, it is almost the same.
Next, you only need to hit a few more cannonballs to get more accurate shooting of the Yuanyuan, so the follow -up will be more accurate.
Sure enough, after the first aircraft shell was deviated, a soldier in the artillery who was instructed after the test was to discuss with several engineers from Aoyama Machinery Factory, and at the same time, it was calculated with paper and pen.
After all, this artillery has not experienced too many tests. Many data are inaccurate. Otherwise, you can directly calculate according to the design parameters.
After some calculations, this was the height of the cannon rack, and after a target of an experienced sergeant's old cannon chief, this was again launched.
And this time, the fall of the shell was hit directly at the enemy's artillery position.
Looking at the smoke and dust set off on the opponent's enemy artillery position, Lin Ziran continued to observe with a telescope and said: "This power is good!"
Kong Deyi on the side also said: "Yeah, although the diameter of these seventy -five millimeters is a bit small, not even as the caliber of the five pounds of artillery, but because of the cylindrical bomb body used
In terms of the power of the explosion, it will not be much worse than our nine -pound field guns! "
Several other officers also nodded together. In the past, they were actually a little worried about the 75 mm caliber. They thought that the caliber of this stuff was too small and the power would not be enough.
But now I see a shells falling among the enemy's artillery positions and killed a large range of enemy forces. This is a satisfactory look.
It is estimated that after today, no one will say that there are insufficient power of 75 millimeter -caliber.
However, even so, Kong Deyi still gave Lin Ziran a suggestion: "Adult, although the 75 mm caliber rear arteries are not weak, but in the final analysis
A large -caliber artillery with a hundred millimeters of 100 millimeters, more than one hundred millimeters, if there is a 150 millimeters of rear artillery, it is even worse. "
Lin Ziran smiled: "Needless to say, this officer has already instructed the Qingshan Factory to study a larger caliber rear gun, one hundred millimeters, 120 millimeters or even 150 millimeters of rear guns.
The basic design is already completed, so it ’s a bad manufacturing gun!"
"But the larger caliber also has higher requirements for manufacturing capabilities. It is estimated that it will not be able to get it out for a while, so don't expect it in a short time.
It's enough time! "
In fact, Lin Ziran also agreed with Kong Deyi's statement. The larger the caliber of the rear gun, the farther the range, the better.
It ’s just that the Qingshan Machinery Factory has limited technical capabilities. It is so difficult to engage in a 75 millimeter rear gun. It is actually difficult to want to engage in a larger caliber backfield gun gun. It is actually difficult.
Of course, this difficulty refers to the cannon of the long body. If it is only a grenade of the short tube, the difficulty should be smaller. The several large -caliber artillery designed by Qingshan Machinery Factory, except for the one hundred millimeters of the field cannon artillery cannon artillery cannon artillery guns.
In addition, the 120 mm and one hundred and fifty mm are the grenades with short body tube.
After all, the sixth division cannot rely only on the seventy -five millimeters of rear artillery.
Seventy -five millimeters, this caliber is definitely a small caliber for the contemporary Daheng Town town.
caliber.
But the sixth division's current Aoyama rear artillery is only 75 millimeters of caliber!
In Daheng, the terrain is flat, the transportation is good, and the horses are very good at the same time. In many countries, the development of artillery must be towards a large caliber, the road of long -body tube.
Therefore, although the current technology is not home, the Blue Shan Machinery Factory has completed the basic design early. What I need to do next is how to produce it.
After all, the design principles of the lacked artillery after the steel wire bore are the same, the gun cannon material is the same, the cannon bolt structure is the same, and the shell system is the same. In fact, the subsequent large -caliber model only needs to be simply enlarged.
Therefore, there is no problem in design. The only problem is how to create it!
Lin Ziran here, watched the test gun to accurately hit the enemy after the test, and used the advantage of the tail loading, metal fixed bombs. After the artillery was quickly reset, it was directly loaded and then fired.
Far exceeding the front artillery.
Watching the artillery shells falling on the enemy's artillery position, the general leaders of the sixth division were smiling. As driven by this, the opponent's artillery position could be completely killed without a few minutes.
But the generals of the Sixth Division obviously underestimated each other's determination!
Determination of life!
At the moment when a few cannonballs come over, although the artillery of the opponent's artillery position is shocked, they can still stick to their posts.
But when more artillery shells continue to fall, they completely collapsed.
This is still the ordinary artillery, and those artillery officers are actually more scared.
Because they discovered that the shells of their artillery positions turned out to be more than 3,000 meters away.